How To Install The Lincoln Mark Viii Air Suspension Parts

The Lincoln Mark VIII is a luxury coupe car model that was popular from 1993 to 1998. Lincoln marketed this car after being manufactured at the Ford Wixom Assembly Plant. Although this car has been around for a long time, it is still efficient. So, if you have suspension problems on your Lincoln Mark VIII, you can consider installing some new air suspension parts. If this is what you plan to do, then this article should be helpful. 

This post will also address the following core issues:

• How to reset the 1998 Lincoln Mark VIII air ride system
• How to fix the 2000 Lincoln Town Car air suspension
• How to install an air spring

How To Install The Lincoln Mark VIII Air Suspension Parts 

First off, since the Lincoln Mark VIII’s air suspension system has a rear air suspension, you can consider installing a conversion kit. With this kit, you get to upgrade to an air spring.  The air springs are the advanced replacement of the previous coil springs and leaf springs. But first, get the tools.

Tools for Installing Air Suspension Parts In A Lincoln Mark VIII 

Here are the tools you need to install air springs as a part of the air suspension system in a Lincoln Mark VIII

• Hydraulic jack and jack stands, 
• An air suspension conversion kit, 
• And an essential toolbox. 

Here are the instructions on how you can install them safely and properly. But first, visit Vigor air ride to get the rear air suspension airbag or air struts for your Lincoln Mark VIII.

Air Spring Installation

• Turn off the air suspension switch.
• Carefully lift the vehicle with jacks and jack stands 
• Replace the o-rings on the air spring solenoid 
• Install solenoid and replace its retaining clips 
• Put the upper cap of the air spring into the chassis hole and lock it
• Put the lower piston's plastic locking fingers into the lower air suspension arm and lock it in place
•  Change tire and wheel assembly, tauten the wheel hub bolts and lower the vehicle 
• Lower the rear air suspension partly
• Turn on the air suspension switch
• Start the engine

Air Compressor Installation on Lincoln Mark VIII

• Turn off the ignition 
• Turn off the air suspension switch
• Take off the passenger tire
• Remove the inner wheel well
• Take off the plastic air silencer 
• Remove the air filter
• Remove the old or faulty suspension compressor 
• Then insert the rubber mount on the new compressor
• Connect it to the electrical plug
• Tighten the four bolts
• Insert the air filter
• Reinstall the inner wheel well
• Insert the tires 
• Lower the car and turn on the air suspension switch

You should be able to install these parts yourself if you take to these instructions, but if you can't, consult a mechanic for professional assistance.

How To Reset 1998 Lincoln Mark VIII Air Ride System 

Resetting the air ride system of a 1998 Lincoln Mark VIII is quite easy. If you want to reset the air suspension of this vehicle, here is all you have to do. 

• Turn off the ignition.
• Locate and turn the air suspension switch off 

The suspension switch is found below the vehicle at the right passenger footwell. 

• Let the air from the shocks out completely 
• Turn the air suspension switch to the ON position 
• Turn on the ignition and go for a drive 

Note that this drive allows you to check the overall condition of the air suspension system to know if it was successfully reset. If this does not reset the vehicle's suspension system, you would have to seek a mechanics' help quickly. Perhaps some parts of the air suspension have developed some faults/problems. 

How To Fix 2000 Lincoln Town Car Air Suspension? 

Although you can trust the rear air suspension of a Lincoln Town Car, they’ll inevitably develop some faults as they age. So, if you have a 2000 Lincoln Town Car with some air suspension problems, the right thing to do is fix it as soon as you can. 

To fix the 2000 Lincoln Town Car air suspension, you must determine the problem. There are so many things that could be wrong with the air suspension. One common problem of the 2000 Lincoln Town Car is leaky airbags. 

Other problems may come from the air suspension pump or the air spring. The experts at It Still Runs also listed switch terminals, air suspension switches, and relief valves as problems worth troubleshooting when the air suspension develops a fault.

Here are some air suspension problems associated with this vehicle and how to fix them on your 2000 Lincoln Town Car.

• Fixing Airbag Leakage 

Leaking airbags are a common problem of the 2000 Lincoln Town Car. One thing to note here is that the airbags of this vehicle are filled with pressurized air. This gives the vehicles an adequate balance off the wheels and the axles. However, as a result of this continual function, wear may occur. While wear is not the only issue, the airbags may get punctured, leading you to fix them. You can simply fix this air suspension problem by replacing the airbags. \

• Fixing Air Suspension Compressors 

You will first have to test the air suspension compressors of the vehicle before you can ascertain if it’s a problem. After that, you can determine if you would replace it. 

You should note that although the air suspension problem may not seem outrightly bad, the continued use of a vehicle with some faulty air suspension component can damage the air ride system. So, ensure that once you’ve tested and diagnosed a problem, it is fixed as soon as possible. 

How To Install An Air Spring 

Just like resetting air suspensions, you can install an air spring without technical knowledge. All you need to do is get the required tools and follow a specific set of instructions then you are good to go. So, if you want to install an air spring on your car, this is how you can go about it. 

• Get Yourself Prepared for the Installation

The first stage of every installation process is preparation. All you have to do here is to ensure the required materials and safety precautions are ready beforehand. Some items you will need to install the air spring in your car include a racket, essential toolbox, scan tool, vehicle lifts or jack stands, sockets, and needle nose pliers. Also, get protective gear to stay protected (optional). 

• Locate and turn off the air suspension switch

Once you have the required materials and safety precautions, you will have to turn off the air suspension switch. This prevents the air suspension ECU from attempting to regulate the vehicle's ride height while installing the air spring. Note that there are a variety of ways to locate the air suspension switch. For most vehicles, it is found somewhere around the trunk compartment. For others, it could be around the passenger side footwell.

• Lift the vehicle 

You have to lift the vehicle using the right vehicle lifts or jack and jack stands. Ensure that the lift arms are firmly placed beneath the vehicle. For jacks, ensure that the jack stands are firmly placed beneath the vehicle. 

• Replace the o-rings on the air spring solenoid 
• Install solenoid and replace its retaining clips 
• Put the upper cap of the air spring into the chassis hole and lock it
• Put the lower piston's plastic locking fingers into the lower air suspension arm and lock it in place
•  Change tire and wheel assembly, tauten the wheel hub bolts and lower the vehicle 
• Lower the rear air suspension partly
• Turn on the air suspension switch
• Start the engine 

Note that if you need to remove the old or faulty air springs to install the new one, you will have to do the direct opposite of everything stated here as regards the installation of the air spring. 

Conclusion

Installing the Lincoln Mark VIII suspension part is easy when you have the right tools and guidance (our part), which we believe we have provided. To reset your 1998 Lincoln Mark VIII, ensure that you check the vehicle’s air suspension’s health status. 

You can also consider disconnecting the vehicle’s battery if the suspension problems persist. If this also doesn’t work, then visit the mechanics’ shop. When all things are equal, you shouldn’t experience problems while installing or replacing any suspension parts. 

So, give the vehicle the maintenance that it needs, test the air suspension components, diagnose a problem if there is one, and fix it. That way, the air ride system of your Lincoln automobile would be problem-free, reducing your bills on replacing or fixing parts.  

For more knowledgeable content on these kind of matter:
Common Cadillac Escalade Air Suspension Problems
Cadillac XTS Air Suspension Reset | A Detailed Guide
Clueless? This Is How To Check Your Air Struts